10
V 05/13
CONTROL PANEL
NOTICE
When you switch on the appliance, the temperature set by default is 17 ° C.
In order to activate heating function, you need to set a temperature of about 2 ° above room temperature.
In this case ECO mode is in automatically in operation; only when heating is active, you can select COMFORT
mode, if desired.
When the set temperature is reached, the icon ECO or COMFORT turns off, and turns back again only when
room temperature falls below the set temperature.
NOTICE
This appliance is equipped with:
1. An UV lamp, with germicidal effect.
2. A ionizer: it emits negative ions and purifies the air in the room.
Both are always active while the appliance is in operation.
The appliance is fitted with an anti tip-up device that prevents it from operating when it detects that the product is inclined.
Do not position the appliance on its side or upside down.
WARNING: ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE.
WHEN YOU TURN THE APPLIANCE ON AGAIN, AFTER SWITCHING IT OFF BY MEANS OF THE
BUTTON ON/OFF AND REMOVING THE PLUG FROM THE SOCKET YOU HAVE TO RESET THE
DESIRED MODE (ECO/COMFORT), TEMPERATURE AND OSCILLATION FUNCTION (SWING).
ON/OFF button
Touching the ON/OFF button the
appliance will begin to operate.
Touching the button ON/OFF once again
the appliance will switch off. To switch
off the fan heater completely, place the
on/off button in the “0” position.
ECO/COMFORT selection button
- ECO mode: 1000 W, reduced power to
save energy
- COMFORT mode: maximum heating
power (2000W)
ECO is the default mode when the set
temperature is higher than room
temperature.
SWING button
When the unit is operating, touch the
SWING button to make the appliance
oscillate automatically, shifting the air
flow from left to right. The LED
is
switched on simultaneously.
Touch the SWING button once again to
interrupt the oscillation and switch off the
LED
.
TIMER / TEMPERATURE button
When the appliance is operating, the operating time can be set by touching this
button: the timer display shows a flashing 0 and the + and - buttons can be
operated to set the desired time, between 1 and 23 hours, with each touch
corresponding with 1 hour. The display shows the set time: wait 5” for the
setting to be confirmed. The unit will switch off automatically at the end of the
programmed time.
After the timer has been set, touching the button once again will allow you to
set the temperature: the display will show ambient temperature and, by
operating the + and - buttons, the desired temperature can be set between 15 and
35°C. Once the desired temperature has been set, wait 5” for the setting to be
confirmed. After 5” the display will show the ambient temperature once again.
NOTICE - The default temperature is 17°C.
Buttons + and -
Allows you to adjust the
temperature and timer settings of
the appliance.
(4 Seiten)
(2 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern